The ease of use and functionality of the MIT410/2 allow testing insulation, continuity and frequency to be done hassle-free. With the ergonomic design of the MIT410/2 it is incredibly convenient for any electrician to use and carry in their toolkit, this coupled with the simple adjustable dial that allow changing between tests to be straight forward are what puts the MIT410/2 apart.
Enhanced testing capabilities
The feature set on the MIT410/2 covers all the basic insulation and continuity checks an engineer may require. The available test voltages for insulation are 50V, 100V, 250V, 500V and 1000V, with the range up to 200GΩ. The unit can also measure voltage up to 600V with frequency measurement range of 45-450 Hz.
PI and DAB testing
The MIT410/2 can also carry out diagnostic tests that its predecessor (MIT400/2) cannot. The tests are the Polarisation Index (PI) and Dielectric Absorption Ratio (DAR), these tests help to track the performance of motors. The continuity range is from 0.01Ω to 10MΩ, there is also an automatic reverse polarity test.
Built to last
All testers in the MIT4XX/2 series are weatherproof (IP54 rated) and feature a rugged rubber overmould for added protection. A hard carry case is also supplied, providing safe storage for the tester and accessories. The unit is CAT IV 600V safety rated.
This website uses cookies to improve your experience. By clicking “Accept”, you consent to the use of ALL the cookies. However you may visit Cookie Settings to provide a controlled consent.
