Teledyne Flir Vibration and Temperature Remote Sensor (SV89) keeps a constant eye on your critical motors and pumps. It gathers vibration and heat data in one sturdy housing and pushes updates as often as every minute. This rapid flow of facts lets you spot bearing wear long before it stops the line. You save hours of production and cut repair spend.
Versatile Communications
The smart node speaks many industrial tongues. It streams clean values through Modbus, MQTT and OPC UA, so both legacy PLCs and modern cloud apps read it without fuss. Wireless links mean there is no signal cable to run, easing retrofits in tall or crowded areas. Even so, you can still pick a wired route whenever radio rules or steel walls block the air.
Built for Demanding Sites
Rugged build anchors the sensor in tough workshops. An IP66 shell throws off dust and spray, while the ±50 g MEMS core stays linear. You set capture rate from one minute to one day, matching trend detail to your schedule. The extra-wide 10 Hz to 10 kHz band makes slow roll faults and high-speed gear chatter equally clear.
The Teledyne Flir Vibration and Temperature Remote Sensor (SV89) adds a contact probe that notes –20 °C to 80 °C. Seen beside vibration rise, heat tells the true story of failing grease or mis-alignment. Quick magnetic mounts and drag-and-drop dashboards mean your first alarms appear within hours. Every saved shutdown proves the unit’s small cost wise.
Key Features
- Continuous insight into vibration and heat status
- Adjustable capture interval fits any maintenance plan
- MEMS accelerometer flags imbalance misalignment looseness
- RMS peak crest factor spectrum view in one graph
- Embedded alarm rules send email or PLC bit
- Wide dynamic range records heavy impact without clipping
- Wireless install saves time and costly cabling runs
- Secure link keeps plant data private and intact
- Tough IP66 shell resists dust oil and spray
- Simple magnetic mount enables tool free swap